The Smart Tray -
Detailed Drawings
Types of Tray
The
Smart Tray is manufactured from BBA Approved Plastisol (plastic
coated, Zinc Plated Steel). Copyright © Patent No GB 2371568
Smart
Tray Sections
Copyright © Patent No GB 2371568
Smart
Tray Sections
Typical
bed joint installation employing Integral Flashing Trays over a lean
to Roof. Copyright © Patent No GB 2371568
Smart
Tray Sections
Typical
roof plane installation employing Integral Flashing Trays with
slimline catcher trays at tray run ends allowing the collected
ingressed water out of the wall. Copyright © Patent No GB 2371568
Catcher
Tray
Once the Smart Tray is
installed into the wall, it is then wedged tight with approved
packers, the remaining gap (aprox 3mm) is then grouted with a
sand/cement mortar aprox 3:1 mix with an integral PVA additive.
Dependant on the surrounding wall colour a Low modulus silicone
sealant can then be applied on to the tray edge if required .Weep
vents are fitted at two brick intervals on bed joint installations,
and central on catcher trays where a roof plane installation has
been employed. The final finish is then one of a more aesthetic
built in appearance.
Copyright © Patent No GB 2371568
|
